This is a hot-pour, plasticized sulfur base compound, mainly used with acid resisting bricks to protect floors, pickling tanks, sumps etc. Sulfur is used with acid resistant brick and tile to protect storage tanks, floors, drains, sumps, pits, pickling tanks in steel & electro plating industries, tube mills etc.
Color Black Mix Ratio by wt. Sol to Powder HotMelt Compressive Strength kg/cm2 275 Flexural Strength kg/cm2 70 Bond Strength kg/cm2 5 Water Absorption 1% Max. Temp. 90 C Setting Time In Hours 2 Hrs.
METHOD OF APPICATION:
Break the sulfur bricks into very small pieces and place in clean, dry heating pan. Start melting it with slow heating and stir it while heating until you get free flowing smooth liquid. Then pour between the joints of acid resistance bricks/tiles. Avoid air pocketing while filling the joints.
CHEMICAL RESISTANCE PROPERTIES:
Sulfur is recommended against non-oxidizing acids, diluted oxidizing acids and acidic and neutral salts at recommended temperature. It is not recommended for use against alkalis, Hydrofluoric acid, fluoride salts etc. For this, 100 % carbon filled sulfur "C” is available.
STORAGE & SAFETY:
Always keep sulfur away from direct heat and in dry place. It can be stored like this, for unlimited period.
Sulfur is supplied in 40 kgs (NET) bags.
HEALTH & SAFETY:
It is advisable to wear protective wears at the time of use of SULFUR and any other our products. rovide adequate ventilation while melting. Handle with care when hot. In case of inhalation of fumes, remove person to fresh air. In case of contact with skin or eyes, contact a doctor immediately. This information, given in good faith, is based on results gained from experience and tests. However, all recommendations or uggestions are made without guarantee since the conditions of use are beyond our control.